FreeDSM/Assembly.md

@@ -18,7 +18,11 @@
 | ![](img/A_pcbF.jpg) | Prepare the PCB with 4 blocks of 4 pins. Here is the PCB front, with connections for 3.3V / GND / SCL / SDA|
 | ![](img/A_pcbB.jpg) | PCB back, joined pins of each block|
 | ![](img/A_side_pcb.jpg) | Fix PCB with 4 screws and connect the dupont cables for the sensors: SDA (purple), SDL (green), 3.3V (orange), GND (brown)|
-| ![](img/A_back.jpg) | Back side of the device (charge regulator side)|
+| ![](img/A_side_pcb_wired.jpg) | Connect the wires from both sensors in each block of colors|
+| ![](img/A_AHT_sensor.jpg) | Use one screw to fix the AHT sensor and pass the 4 wires to the PCB side|
+| ![](img/A_TSL_wires.jpg) | Pass the wires of TSL2591 on the top side of the chassis|
+| ![](img/A_TSL_screw.jpg) | Screw the sensor TSL2591 |
+
 | ![](img/A_switch.jpg) | Solder both white wires to the switch|
 | ![](img/A_front.jpg) | Front complete (display, switch and USB-C port)|
 | ![](img/A_TSL2591c.jpg) | Top support for TSL2591 with screws and wires|