FreeDSM/Assembly.md

@@ -13,9 +13,11 @@
 | ![](img/A_fullchassis_wires_B.jpg) | Complete chassis with wires (charge regulator side)|
 | ![](img/A_MCP_battery.jpg) | MCP battery charge controller|
 | ![](img/A_head_bat.jpg) | MCP connections detail|
-| ![](img/A_MCP_detail_full.jpg) | MCP - switch ON/OFF - USB-C connections|
-| ![](img/A_pcbF.jpg) | PCB front, with connections for 3.3V / GND / SCL / SDA|
-| ![](img/A_pcbB.jpg) | PCB back, joined pins in the back|
+| ![](img/AA_side_regulator.jpg) | Stick battery and regulator with double side tape and connect the Dupont connectors LOAD(blue) and GND (white) |
+| ![](img/A_side_regulator_full.jpg) | Solder USB-C wires and yellow wire for battery monitoring (protected with tape) |
+| ![](img/A_pcbF.jpg) | Prepare the PCB with 4 blocks of 4 pins. Here is the PCB front, with connections for 3.3V / GND / SCL / SDA|
+| ![](img/A_pcbB.jpg) | PCB back, joined pins of each block|
+| ![](img/A_side_pcb.jpg) | Fix PCB with 4 screws and connect the dupont cables for the sensors: SDA (purple), SDL (green), 3.3V (orange), GND (brown)|
 | ![](img/A_back.jpg) | Back side of the device (charge regulator side)|
 | ![](img/A_switch.jpg) | Solder both white wires to the switch|
 | ![](img/A_front.jpg) | Front complete (display, switch and USB-C port)|