FreeDSM/Assembly.md

@@ -17,7 +17,7 @@
 | ![](img/A_side_regulator_full.jpg) | Solder USB-C wires and yellow wire for battery monitoring (protected with tape) |
 | ![](img/A_pcbF.jpg) | Prepare the PCB with 4 blocks of 4 pins. Here is the PCB front, with connections for 3.3V / GND / SCL / SDA|
 | ![](img/A_pcbB.jpg) | PCB back, joined pins of each block|
-| ![](img/A_side_pcb.jpg) | Fix PCB with 4 screws and connect the dupont cables for the sensors: SDA (purple), SDL (green), 3.3V (orange), GND (brown)|
+| ![](img/A_side_pcbW.jpg) | Fix PCB with 4 screws and connect the dupont cables for the sensors: SDA (purple), SDL (green), 3.3V (orange), GND (brown)|
 | ![](img/A_side_pcb_wired.jpg) | Connect the wires from both sensors in each block of colors|
 | ![](img/A_AHT_sensor.jpg) | Use one screw to fix the AHT sensor and pass the 4 wires to the PCB side|
 | ![](img/A_TSL_wires.jpg) | Pass the wires of TSL2591 on the top side of the chassis|