| Picture | Description |
|---|---|
 |
Main components. Additionally, 2 100 Ohm resistors and pin header not in the picture |
 |
Pin soldering ESP32 C3 CORE and Air 101 display |
 |
Screw the display to the round part |
 |
This is how it looks from the outside |
 |
Wiring scheme |
 |
Wires connected to the ESP32 |
 |
TSL2591 and AHT21 with wires |
 |
Complete chassis with wires |
 |
MCP battery charge controller |
 |
MCP connections detail |
 |
MCP - switch ON/OFF - USB-C connections |
 |
Chassis mounted, except TSL2591 top support and round front (display) |
 |
PCB front, with connections for 3.3V / GND / SCL / SDA |
 |
PCB back, joined pins in the back |
 |
Back side of the device (charge regulator side) |
 |
Solder both white wires to the switch |
 |
Front complete (display, switch and USB-C port) |
 |
Top support for TSL2591 with screws and wires |
 |
Top support fitted in the upper part |
 |
TBC |
Last edited by 
José Carlos Dafonte Vázquez
José Carlos Dafonte Vázquez